Changing SELinux Modes

Security Enhanced Linux is a Linux security module for mandatory or role-based access control. SELinux is packaged with CentOS and Fedora by default, and can be running in one of three modes : disabled, permissive or enforcing.

Ideally, you want to keep SELinux in enforcing mode, but there may be times when you need to set it to permissive mode, or disable it altogether. Note that the disabled state means the daemon is still running and is still enforcing rules for discretionary access control , however no MAC security policies are being used, and no violations are being logged.

1. View the current enforcement mode of SELinux on your system using sestatus. You can see below that SELinux is set to permissive mode.

   [root@centos ~]# sestatus
   SELinux status:                 enabled
   SELinuxfs mount:                /sys/fs/selinux
   SELinux root directory:         /etc/selinux
   Loaded policy name:             targeted
   Current mode:                   permissive
   Mode from config file:          permissive
   Policy MLS status:              enabled
   Policy deny_unknown status:     allowed
   Max kernel policy version:      28
   

2. Change to enforcing mode using setenforce. This will be for the current runtime session only. You’ll need to edit the SELinux configuration file if you want the setting to survive a reboot.

   setenforce 0    # Set to permissive mode.
   setenforce 1    # Set to enforcing mode.
   

3. Edit the SELinux configuration file so your mode change will survive reboots. The sed command below is given as an example, and will switch from permissive to enforcing mode. For a different mode configuration, just substitute the two words in the command with the mode you currently have, and the one you want to enable (ex. disabled to permissive).

   sed -i 's/SELINUX=permissive/SELINUX=enforcing/g' /etc/selinux/config
   

   If you prefer to edit the file manually, it should look like this:

   File: /etc/selinux/config

   1 2 3 4 5 6 7 8 9 10 11

   # This file controls the state of SELinux on the system. # SELINUX= can take one of these three values: # enforcing - SELinux security policy is enforced. # permissive - SELinux prints warnings instead of enforcing. # disabled - No SELinux policy is loaded. SELINUX=enforcing # SELINUXTYPE= can take one of three two values: # targeted - Targeted processes are protected, # minimum - Modification of targeted policy. Only selected processes are protected. # mls - Multi Level Security protection. SELINUXTYPE=targeted

4. Reboot your Linode. During the bootup process, SELinux may need to run a relabeling of the filesystem. It will handle this automatically and when it’s done, it’ll reboot the system. If you do not have Lassie enabled, the Linode will shut down and you will need to manually reboot in the Linode Manager.

   

5. When your Linode boots back up, log in and verify that SELinux is now running in the new enforcement mode. Run sestatus again. The output should show that you’re in the mode you set in steps 2 and 3 above.

   [root@centos ~]# sestatus
   SELinux status:                 enabled
   SELinuxfs mount:                /sys/fs/selinux
   SELinux root directory:         /etc/selinux
   Loaded policy name:             targeted
   Current mode:                   enforcing
   Mode from config file:          enforcing
   Policy MLS status:              enabled
   Policy deny_unknown status:     allowed
   Max kernel policy version:      28
   

More Information

You may wish to consult the following resources for additional information on this topic. While these are provided in the hope that they will be useful, please note that we cannot vouch for the accuracy or timeliness of externally hosted materials.

• Security Enhanced Linux User Guide, Red Hat
• SELinux, CentOS Wiki